This jeep uses a nag1 transmission with ATF+4 fluid. Pan bolts are torqued to 71in.lbs.This method only works if you have the correct fluid level to start wi Upon further investigation the Technician may find that the following Diagnostic Trouble Code (DTC) has been set: • P0520 - Engine Oil Pressure Sensor Circuit. REPAIR PROCEDURE: 1. Replace the oil pressure sensor. 2014 Grand Cherokee 5.7 Overland. 2014 Wrangler Rubicon. 5.28 US qt. 4.4 UK qt. 5 L. Automatic transmission fluid: ATF+4. Without special equipment it is possible to replace only ATF in the AT pan because of the way automatic transmission in 2012 Jeep Grand Cherokee has been designed. It will take about 30 – 90 minutes depends on your skill level and might save you up to $200 depends on the region One of the most serious issues that can happen to your Jeep Grand Cherokee ‘s engine is if it ends up with low oil pressure. Low oil pressure will cause the engine to seize up. When the oil pressure light on, it should be assumed that the engine locking up is imminent. We advise not running the engine until the issue can be properly diagnosed. This video demonstrates how to reset the "oil change due" message on your 2011-2020 Jeep Grand Cherokee models. This also works for other Mopar vehicles as w I walkthrough on how easy it is to change your oil & oil filter on your 3.6L V6 Jeep Grand Cherokee. 👇My RECOMMENDED Tools & Other Things:💻 Amazon LinksOIL 08zx10r. 46 posts · Joined 2012. #7 · Jun 13, 2013. I changed my oil at 1200 miles on my 14 SRT and used the recommended Pennzoil Ultra 0W40 with an Amsoil EaO11 oil filter. Next change will be when ever the Evic says or at a max of 6000 miles. H. No need for the overpriced ZF LifeGuard 8 fluid. I made a handy fluid transfer pump from a one gallon yard sprayer, only $10 at home depot. I added 1/2" clear tubing, a plastic ball valve, and a plastic 90º fitting on the end. The plastic end fitting fits perfectly in the fill hole. LQM5A.